Catwoman was printed at 150% on a Voxelab Aquila FDM printer at .16 of a layer. The print was 8 pieces total. I did make a mistake, the bottom base was too large to print (I didn’t realize this until after the body was printed, haha lesson learned).
The 2021 Lovely Ladies GB – Catwoman
I always liked the shiny suit but hated the white stitching seen in the movie. I opted to leave those out. The figure was painted with Vallejo Air using an airbrush. Bricks on the base were airbrushed with several colors and a couple of washes. Then used some Vallejo streaking grime to finish it off.
I placed the figure and bricks on a wooden base.